|
Who's Online
There currently are 5980 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
;
Great Manual! It contains all the wiring schematics and mechanical exploded views that are essential for service and repair. I was surprised I even found this for such an old machine. Only wish I knew of this site many years ago.
;
Great manual very clear copied. You are making an incredible job. I appreciate a lot the rapidity and your efficiency. Thanks a lot
;
Good pdf of the service manual for this unit. Includes disassembly instructions, full schematics, board layouts, parts lists and diagnostic information. Some information is in the pdf twice (single pages, and split pages), but that could be how it was originally generated by panasonic, or perhaps the idea is to make it eaiser to put onto 8.5 x 11" pages.
Information was exactly what I needed. Delivery was overnight (less than 12 hours) and I was happy with the process.
Removal and Replacement Procedures � LaserWriter 10/600 A3+
4 � 45
RRP2.13 Heat Roll (PL2.14)
Warning : Turn power off, remove the EP Cartridge and disconnect the power cord before performing the following procedure. Removal Caution : Perform the following procedure after the temperature of the Fuser Assembly has gone down suf�ciently. 1. Remove the Left Cover. (RRP1.1) 2. Remove the Top Cover Assembly. (RRP1.2) 3. Remove the Right Cover. (RRP1.4) 4. Remove the Rear Panel. (RRP6.1) 5. Remove the Pop Up Assembly. (RRP1.5) 6. Remove the Rear Frame Assembly. (RRP1.6) 7. Remove the Fuser Assembly. (RRP2.1) 8. Remove the Fuser Top Cover Assembly. (RRP2.4) 9. Remove the Exit Chute. (RRP2.5) 10. Remove the Fuser Cover L and P/R Earth Plate L. (RRP2.2) 11. Remove the Fuser Cover R and P/R Earth Plate R. (RRP2.3) 12. Remove the Heater Rod. (RRP2.10) 13. Remove the Pressure Roll. (RRP2.12) 14. Remove the Nip Lever L, Nip Lever R, and P/R Eliminator.(Figure2.12) 15. Remove the screw(gold, Tap, 8mm) securing the H/R Diode, and remove the H/R Diode. 16. Remove the H/R Ring securing the left side of the Heat Roll, and remove the H/R Gear and H/R Bearing L. Caution : In the next step, be careful not to damage the Heat Roll. 17. Slide the H/R Bearing R to the right to remove it from the Fuser Frame Assembly, then remove the Heat Roll with the right H/R Ring and H/R Bearing R. 18. Remove the right H/R Ring and H/R Bearing from the Heat Roll. Replacement Reverse the removal procedures for reinstallation. Caution : Install the Temperature Sensor Assembly so that its thermistor (tape) face contacts the Heat Roll. Note : Be sure to install the H/R Diode for the correct position.
|
|
|
> |
|